RAID 4-Bay Manual de usuario descargar pdf (Pagina 11)

Chapter 4

HDD installation and setting of a hard disk

4-1 To install the Hard disks

Please remove the plug from the power supply outlet before assembling the hard disk, it will

cause an electric shock and/or damage if not disconnected.

1. Press 2 blue door latches inward to release the tray lock, then pull out

the tray.

2. Put the HDD on the tray and make sure the HDD screw holes on the

bottom are aligned to the 4 posts on the tray.

3. Lock the HDD in the tray by pressing the side plate onto each side of

the tray, and connect with the HDD.

4. Slide the installed trays back to the enclosure, a click sound is heard

to confirm the tray is locked in the enclosure. Then connect the eSATA

or USB 3.0 cable and turn ON the device

4-2 The setting of DIP mode switch

First, please relocate the DIP switch at rear side of the case.

A, To reset all RAID modes, please set every DIP SW at OFF position then hold reset button and

turn ON the power of enclosure, then shut down the device and release reset button to complete

the mode reset.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 20 21

Sin comentarios

RAID 4-Bay Manual de usuario Pagina 11